Flrig v1.3.54 now available

The FLdigi development team led by W1HKJ have announced the release of Flrig v1.3.54. Flrig is a transceiver control program designed to be used either stand alone or as an adjunct to Fldigi.

As with all of the FL suite, Flrig continues to support both PowerPC and Intel (i386) processors; with individual downloads available for each architecture and can be downloaded here.

Version 1.3.54 

PowerSDR
* Added PowerSDR transceiver
* compatible with Thetis

TS2000
* test for NR; response of ?;

hcomm INVALID HANDLE VALUE
* initialize hcomm to invalid handle value when creating
new WIN32 class instance
* test for open port before attempting to reopen
close port if necessary

External close command
* Fix shutdown segmentation fault encountered during
shutdown initiated by external xmlrpc command

Check PTT
* add check for NON CAT ptt configuration

xmlrpc server
* correction to data types
* change zmsec computation
* allow xmlrpc requests for get/set_power & get_pwrmeter
direct access to xcvr i/o.
* add xmlrpc command rig.tune
. enable transceiver tune function
* update xmlrpc server method list to correctly indicate
signature <ret:arg> types
* rewrite set numeric as integer
* add xml_trace statements to get/set
. volume, mic gain, rf gain, power control

IC7300
* Add get/set trace statements

FT817ND
* add trace statements for testing

FT847
* add get_modetype

macOS serial ports
* update serial port detection function

BigSur serial ports
* Modify port discovery for Big Sur naming convention

Break-in
* Add break-in selection for transceivers which support
set / get CAT commands for break-in
– Icom, Yaesu
– Change enable_break_in to set_break_in
– Add get_break_in
. method
. polling

Bands
* Add missing 1.2 GHz save/restore

IC7300 power table
* modify power table conversion method

Pmax
* return maximum available power to rig.get_pwrmax

Autostart
* Changes to transceiver autostart methods in supported
transceivers

IC7100 auto ON/OFF
* rewrite autostart processing to show time for
xcvr setup. 7100 takes about 5 seconds from a
CAT wakeup command to when it can process additional
commands

Trace/Debug
* Disable text widget update if respective dialog not visible
* Clear Fl_Text_Display buffer when buffer length exceeds 100000
This will prevent excessive use of memory and possibility of
segmentation fault caused by the text display widget.

FT736R update
* added mode type method

xmlrpcpp tracing

TOD clock
* correction to millisecond field

Icom sliders
* adjust min power for 7100, 7300, 9100, 9700